Post on 08-Jan-2018
description
Physics 2113 Physics 2113 Lecture: 16 WED 30 Lecture: 16 WED 30
SEPSEPCapacitance II Capacitance II
Physics 2113
Jonathan Dowling
Capacitors in Parallel: Capacitors in Parallel: V=ConstantV=Constant
• An ISOLATED wire is an equipotential surface: V=Constant
• Capacitors in parallel have SAME potential difference but NOT ALWAYS same charge!
• VAB = VCD = V
• Qtotal = Q1 + Q2
• CeqV = C1V + C2V
• Ceq = C1 + C2
• Equivalent parallel capacitance = sum of capacitances
A B
C D
C1
C2
Q1
Q2
CeqQtotal
V = VAB = VA –VB
V = VCD = VC –VD
VA VB
VC VD
ΔV=VPAR-V (Parallel: V the Same)
Capacitors in Series: Capacitors in Series: Q=ConstantQ=Constant
• Q1 = Q2 = Q = Constant• VAC = VAB + VBC
A B C
C1 C2
Q1 Q2
Ceq
Q = Q1 = Q2
SERIES: • Q is same for all capacitors• Total potential difference = sum of V
Isolated Wire:Q=Q1=Q2=Constant
SERI-Q: Series Q the Same
Capacitors in Parallel and in Capacitors in Parallel and in SeriesSeries
• In series : 1/Cser = 1/C1 + 1/C2
Vser = V1 + V2
Qser= Q1 = Q2
C1 C2
Q1 Q2
C1
C2
Q1
Q2
• In parallel : Cpar = C1 + C2
Vpar = V1 = V2
Qpar = Q1 + Q2 Ceq
Qeq
Example: Parallel or Example: Parallel or Series?Series?
What is the charge on each capacitor?
C1=10 μF
C3=30 μF
C2=20 μF
120V
• Qi = CiV • V = 120V on ALL Capacitors (PAR-V)• Q1 = (10 μF)(120V) = 1200 μC • Q2 = (20 μF)(120V) = 2400 μC• Q3 = (30 μF)(120V) = 3600 μCNote that:• Total charge (7200 μC) is
shared between the 3 capacitors in the ratio C1:C2:C3 — i.e. 1:2:3
Parallel: Circuit Splits Cleanly in Two (Constant V)
Example: Parallel or Example: Parallel or SeriesSeries
What is the potential difference across each capacitor?
C1=10μF C3=30μFC2=20μF
120V
• Q = CserV• Q is same for all capacitors (SERI-Q)• Combined Cser is given by:
• Ceq = 5.46 μF (solve above equation)• Q = CeqV = (5.46 μF)(120V) = 655 μC• V1= Q/C1 = (655 μC)/(10 μF) = 65.5 V• V2= Q/C2 = (655 μC)/(20 μF) = 32.75 V• V3= Q/C3 = (655 μC)/(30 μF) = 21.8 V
Note: 120V is shared in the ratio of INVERSE capacitances i.e. (1):(1/2):(1/3)
(largest C gets smallest V)
Series: Isolated Islands (Constant Q)
Example: Series or Example: Series or Parallel?Parallel?
In the circuit shown, what is the charge on the 10μF capacitor?
10 μF
10μF 10V
10μF
5μF5μF 10V
• The two 5μF capacitors are in parallel
• Replace by 10μF • Then, we have two 10μF
capacitors in series• So, there is 5V across the 10 μF
capacitor of interest by symmetry
• Hence, Q = (10μF )(5V) = 50μC
Neither: Circuit Simplification Needed!
Energy U Stored in a Energy U Stored in a CapacitorCapacitor
• Start out with uncharged capacitor
• Transfer small amount of charge dq from one plate to the other until charge on each plate has magnitude Q
• How much work was needed? dq
Energy Stored in Electric Field of Energy Stored in Electric Field of CapacitorCapacitor
• Energy stored in capacitor: U = Q2/(2C) = CV2/2 • View the energy as stored in ELECTRIC FIELD• For example, parallel plate capacitor: Energy
DENSITY = energy/volume = u/volume =
volume = AdGeneral
expression for any region with vacuum
(or air)
Dielectric ConstantDielectric Constant• If the space between capacitor
plates is filled by a dielectric, the capacitance INCREASES by a factor κ
• This is a useful, working definition for dielectric constant.
• Typical values of κare 10–200 but it is always greater than 1!+Q –Q
DIELECTRIC
C = κε A/d
The κ and the constant εκεo are both called dielectric constants. The κ has no units (dimensionless).Trick: Just substitute εκεo for εo in all the previous formulas!
Atomic View
Emol
Ecap
Molecules set up counter E field Emol that somewhat cancels out capacitor field Ecap.
This avoids sparking (dielectric breakdown) by keeping field inside dielectric small.
Hence the bigger the dielectric constant the more charge you can store on the capacitor.
• Capacitor has charge Q, voltage V• Battery remains connected while
dielectric slab is inserted.• Do the following increase,
decrease or stay the same:– Potential difference?– Capacitance?– Charge?– Electric field?
dielectric slab
Example: Battery Connected — Example: Battery Connected — Voltage V is Constant but Charge Q Voltage V is Constant but Charge Q
Changes Changes
• Initial values: capacitance = C; charge = Q; potential difference = V; electric field = E;
• Battery remains connected• V is FIXED; Vnew = V (same)• Cnew = κC (increases)• Qnew = (κC)V = κQ (increases).• Since Vnew = V, Enew = V/d=E (same)
dielectric slab
Energy stored? u=ε0E2/2 => u=κε0E2/2 = εE2/2 increases
Example: Battery Connected — Example: Battery Connected — Voltage V is Constant but Charge Q Voltage V is Constant but Charge Q
Changes Changes
• Capacitor has charge Q, voltage V• Battery remains is disconnected then
dielectric slab is inserted.• Do the following increase,
decrease or stay the same:– Potential difference?– Capacitance?– Charge?– Electric field?
dielectric slab
Example: Battery Disconnected — Example: Battery Disconnected — Voltage V Changes but Charge Q is Voltage V Changes but Charge Q is
Constant Constant
• Initial values: capacitance = C; charge = Q; potential difference = V; electric field = E;
• Battery remains disconnected• Q is FIXED; Qnew = Q (same)• Cnew = κC (increases)• Vnew = Q/Cnew = Q/(κC) (decreases).• Since Vnew < V, Enew = Vnew/d = E/κ
(decreases)
dielectric slab
Energy stored?
Example: Battery Disconnected — Example: Battery Disconnected — Voltage V Changes but Charge Q is Voltage V Changes but Charge Q is
Constant Constant
SummarySummary• Any two charged conductors form a capacitor.• Capacitance : C= Q/V
• Simple Capacitors:Parallel plates: C = ε0 A/dSpherical : C = 4π ε0 ab/(b-a)Cylindrical: C = 2π ε0 L/ln(b/a)
• Capacitors in series: same charge, not necessarily equal potential; equivalent capacitance 1/Ceq=1/C1+1/C2+…
• Capacitors in parallel: same potential; not necessarily same charge; equivalent capacitance Ceq=C1+C2+…
• Energy in a capacitor: U=Q2/2C=CV2/2; energy density u=ε0E2/2
• Capacitor with a dielectric: capacitance increases C’=κC