Impact of jet - site.iugaza.edu.pssite.iugaza.edu.ps/t77328/files/Experiment-31.pdf · A PPLICATION...

Post on 06-Feb-2018

217 views 1 download

Transcript of Impact of jet - site.iugaza.edu.pssite.iugaza.edu.ps/t77328/files/Experiment-31.pdf · A PPLICATION...

EXPERIMENT (3)

IMPACT OF JET

By:Eng. Motasem M. Abushaban.

Eng. Fedaa M. Fayyad.

RATE OF FLOW

Rate of flow

Volume rate of flow

Mass rate of flow

IMPULSE MOMENTUM EQUATION

( )( )12

12

vvmFvvQF

−=−=

ρ

IMPULSE MOMENTUM EQUATION

Resultant force acting on the fluid is made up of three components:

1. F1 = FR: by any solid body touching the control volume

2. F2 = FB: body force such as gravity3. F3 = FP: fluid Pressure

The Force exerted by the fluid on the solid body is opposite to FR

The reaction force R is given by:R = - FR

APPLICATION OF THE MOMENTUM EQUATION

Impact of a jet on a plane surface Force due to flow round a curved vane Force due to the flow of fluid round a pipe bend Reaction of a jet

PURPOSE

To investigate the reaction force produced by the impact of a jet of water on various target vanes.

Impact Jet Apparatus

PROCEDURE: Position the weight carrier on the weight platform and

add weights until the top of the target is clear of thestop and the weight platform is floating in mid position.

Start the pump and establish the water flow by steadilyopening the bench regulating valve until it is fully open.

The vane will now be deflected by the impact of the jet. Place additional weights onto the weight carrier until

the weight platform is again floating in mid position. Measure the flow rate (volume collected in certain time)

and record the result on the test sheet, together with thecorresponding value of additional weight on the tray.

Observe the form of the deflected jet and note its shape.

PROCEDURE:

Reduce the weight on the weight carrier in steps andmaintain balance of the weight platform byregulating the flow rate in about eight or ten evensteps.

Close the control valve and switch off the pump.Allow the apparatus to drain.

Replace the 5mm nozzle with the 8mm diameternozzle and repeat the tests.

Replace the normal vane with the conical vane andrepeat the test with both the 5mm and 8mm nozzles.

Replace the conical vane with the hemispherical vaneand repeat the test with both the 5mm and 8mmnozzles.

DATA & RESULTS:

Target Vanes (degrees)

Nozzle Dia-- d -- (mm)

Additional Weights-- m -- (gm)

Volume of Collected water - V - (Liter)

Time to collect -- t -- (sec)

°

590θ=

Flat 8

°

545θ=

Coni

cal

8

°

5135

θ=Se

mi-

sphe

rica

l

8

12

QUESTIONS