Post on 10-Jan-2016
description
© 2005 Swagelok Company.
© 2005 Swagelok Company.
Design Features
Controlled-phased sequential pull-up
Patented recessed and contoured geometry
Patented case-hardening process
Hinging colleting action
© 2005 Swagelok Company.
Design Features
Controlled-phased sequential pull-up
Patented recessed and contoured geometry
Patented case-hardening process
Hinging colleting action
© 2005 Swagelok Company.
Design Features
Controlled-phased sequential pull-up
Patented recessed and contoured geometry
Patented case-hardening process
Hinging colleting action
© 2005 Swagelok Company.
Design Features
Controlled-phased sequential pull-up
Patented recessed and contoured geometry
Patented case-hardening process
Hinging colleting action
© 2005 Swagelok Company.
Swagelok Tube Fitting
Tube Grip
© 2005 Swagelok Company.
Swagelok Tube Fitting
Gas Seal
© 2005 Swagelok Company.
Swagelok Tube Fitting
Vibration Resistance
© 2005 Swagelok Company.
Design Differences
Single Ferrule Bite-Type Fitting Twin Ferrule Bite-Type Fitting
Hinging Colleting Grip-Type Fitting(Swagelok Tube Fitting)
Tube Grip
© 2005 Swagelok Company.
Comparing TechnologyTube Grip
Tube Gripping Indent
© 2005 Swagelok Company.
Swagelok Tube FittingTube Grip
© 2005 Swagelok Company.
Swagelok Tube FittingTube Grip
Robust grip over a wide range of installations
Tubing
Hardness
Wall thickness
Dimensions
Material
Quality
Pull-up
© 2005 Swagelok Company.
Swagelok Tube Fitting
Gas Seal
© 2005 Swagelok Company.
Design DifferencesVibration Resistance
© 2005 Swagelok Company.
Design DifferencesVibration Resistance
Stress Riser
© 2005 Swagelok Company.
Swagelok Tube FittingVibration Resistance
Hinging Colleting Grip-type Fitting
© 2005 Swagelok Company.
Design Differences
Enhanced factors of installed tube fitting performance
Over a wide range of installations
Ease of installation
Summary of Advantages…Fact versus Perception
© 2005 Swagelok Company.
Initial Installation Procedures … in 3 Easy Steps
Insert the tube into the Swagelok tube fitting…
making sure that the tubing rests firmly on the shoulder of the tube fitting body and that the nut is finger-tight.
Mark the nut at the 6 o’clock position While holding the fitting
body steady, tighten the nut 1 1/4 turns to the 9 o’clock position.
© 2005 Swagelok Company.
Sufficiently Tightened Additional Tightening Required
Initial Installation Procedures
Gaugeability
© 2005 Swagelok Company.
Swagelok Limited Lifetime Warranty
© 2005 Swagelok Company.
Third Party Testing
Third parties include:TÜV [ECE R110]
DNV
Lloyds Register
American Bureau of Shipping
ASTM F1387 as witnessed and approved by the U.S. Navy
© 2005 Swagelok Company.