95CH8

8. Turret Robot

96CH8

Put up a rubber band between the wheel and the tip of the barrel

on turret to cause tensions. And use 1 DC motor to rotate the gun

turret, ready to shoot at a target.

When the rubber band hung on barrel rotates the wheel to barrel di-

rection, it gets ready to shoot off. On this occasion, the momentum of

the rubber band also increases to the proportion of wheel’s rotating

speed. If the rotating speed of wheel is adjusted, shooting range of

the rubber band is able to be adjusted.

The rotating wheel enables

a rubber band to shoot off.

Rubber

band rack

Introduction

and

how it works

97CH8

X 4 X 8

X 2 X 2

98CH8

X 4

X 4

X 1

99CH8

X 4

X 8 X 4

X 4

100CH8

X 4

101CH8

X 2

X 4 X 4

X 2X 2

102CH8

X 2

103CH8

X 12 X 12

X 8 X 8

X 1 X 1

104CH8

X 1 X 2

X 2

X 2X 2 X 1

105CH8

X 4

106CH8

X 4 X 4

107CH8

X 1

108CH8

M1

M2

M2 M1

completion

Left view

Right view

109CH8

Turret Robot uses program mode 8 to operate.

Connect the rubber band

to the wheel.

1. Load

Move the turret right or left by touching

the right or left sensors.

2. Aim

When the center sensor detects your

hand, the robot will fire the rubber band.

3. Fire

Acting

Module

110CH8

1. Connect the rubber band to the robot. (Do not shoot it at people)

2. Uses paper cups to make a tower with 3~4 floors. Use one cup for the

very top floor. Then, locate your robot 2m away from the tower.

3. Move your turret left and right to aim the robot at the cup on the very top.

When there are many players, set up a time limit of 10~30 seconds. It will

be more fun!

4. After you are done with aiming, fire the rubber band.

5. When the cup at the very top falls down by the rubber band, you will get a

point.

Play the

Game!