Post on 12-Apr-2017
CO-DEVELOPMENT
MANUFACTURING INNOVATION & SUPPORT
Akbar Pamungkas SukasdiFinal Internship Presentation
Agenda 3T BV Company Profile Introduction Assignment Project Summary Design Block Diagram Design Layout Results Recommendations
May 3, 2023www.3t.eu 2
Founded in 1982, 3T since 1994 45 – 50 employees (mainly MSc/BSc) Offices in Enschede (HQ) & Eindhoven Does co-development, product innovation &
support
May 3, 2023www.3t.eu 3
Introduction Born in Batam, Riau Islands, Indonesia 3rd year student of EPA Elektrotechniek Sep 2014 – Jan 2015 : 1st Internship Period in 3T
BV 2012 – 2016 : Bachelor of Electrical & Electronic
Engineering in Saxion University of Applied Sciences
May 3, 2023www.3t.eu 4
Assignment Construct and test a DC/DC Converter using push
pull topology scheme (incorporating galvanic isolation).
Topology : Push Pull Topology Input : 18 – 36 VDC Output : +/- 15 VDC Output Voltage Ripple : 150 mV peak-to-peak Efficiency : ≥ 89 % Output Power : 40 W Isolation
May 3, 2023www.3t.eu 5
Project Summary The project has investigated why custom DC-DC
converter should be made The project has considered that high efficiency and
low noise operation should be part of the final design
The project has recommended to give more attention to the components selection and careful PCB layout
May 3, 2023www.3t.eu 6
Design (Block Diagram)
May 3, 2023www.3t.eu 7
Design (PCB Layout)
May 3, 2023www.3t.eu 8
All components are on the top Short traces Compact size (143 mm x 56.5 mm) Most SMD components are used Provides heatsink Isolation
Design (PCB Layout) Component top:
Top Layer (Signal Layer):
May 3, 2023www.3t.eu 9
Design (PCB Layout) Second Layer (Ground Plane):
• Barrier width : 1.5 mm
Third Layer (Power Plane)
May 3, 2023www.3t.eu 10
Design (PCB Layout)
May 3, 2023www.3t.eu 11
Bottom Layer (Signal Layer):
Results Stable +/- 15 VDC dual output voltages Low ripple output voltages (17.60 mV p-p) High efficiency up to 92% (Full Load)
May 3, 2023www.3t.eu 12
Results Thermal picture:
May 3, 2023www.3t.eu 13
Recommendations Integrated Heatsink (Thermal Management) Use Thermal Blind / Buried Vias (Thermal
Management) Package Development (Thermal Management) MOSFETs w/ ultra low gate charge (Qg) (Efficiency) Ultra low forward voltage Schottky diodes
(Efficiency) Use lead wire instead of solid copper wire
(Efficiency)
May 3, 2023www.3t.eu 14
3T B.V.Institutenweg 6 Esp 4017521 PK Enschede 5633 AJ EindhovenThe Netherlands The Netherlands
T. +31 53 4 33 66 33F. +31 53 4 33 68 69E. info@3t.nlW. www.3t.eu