Post on 15-Jan-2016
description
© 2006 NOKIA 1 mikko.o.makinen@nokia.com 1.12.2006
3G Media Gateway Software for GSM
Transcoder
Author: Mikko Mäkinen
Supervisor: Professor Raimo Kantola
Instructor: Lic.Sc. (Tech) Jyri Suvanen
© 2006 NOKIA 2 mikko.o.makinen@nokia.com 1.12.2006
Contents of the presentation• Objectives of the thesis
• Speech transcoding in mobile networks
• Role of TRAU (Transcoder and Rate Adaptation Unit) and MGW (Media Gateway) in GSM and 3G networks
• Digital Signal Processing (DSP) Hardware and Software (HW/SW)
• Comparing TRAU and MGW software
• Applying MGW software for TRAU environment
• Performance of the new software
• Conclusions
© 2006 NOKIA 3 mikko.o.makinen@nokia.com 1.12.2006
Objectives of the thesis• Problem:
• Two separate network elements (TRAU and MGW) are handling basically the same task i.e. transcoding speech. However, their development has been relatively independent in Nokia up to this date.
• Methods:• Study the roles of the TRAU and the MGW unit in current and
future network architectures• Comparison of the MGW and the TRAU software• Apply the MGW software in the TRAU hardware environment
and implement needed software parts• Feasibility & performance study of the new software
• Thesis was carried out in Nokia Network’s Signal Processing System unit
© 2006 NOKIA 4 mikko.o.makinen@nokia.com 1.12.2006
Speech transcoding in mobile networks• Radio frequencies are scarce and expensive resource
• Speech encoding saves radio channels remarkably• Traditional PCM (64kbit/s) versus HR (5.6kbit/s), FR (13kbit/s),
EFR(12.2kbit/s) and AMR-NR(4.75-12.2kbit/s)
• Exploitation of the statistical characteristics of the human speech• Short term correlation – linear prediction• Long term correlation – fundamental period of voiced sounds
• Hybrid coders – combination of waveform coders and vocoders
• Compatible interconnections towards other wireless and wireline networks usually implemented with PCM
© 2006 NOKIA 5 mikko.o.makinen@nokia.com 1.12.2006
Role of TRAU and MGW (1/3)
MS – Mobile Station
BTS – Base Transceiver Station
BSC – Base Station Controller
TRAU – Transcoding and Rate Adaptation Unit
MSC – Mobile Switching Station
GMSC – Gateway MSC
VLR – Visitor Location Register
HLR – Home Location Register
AuC – Authentication Centre
EIR – Equipment Identity Register
PSTN – Public Switched Telephone Network
PLMN – Public Land Mobile Network
• TRAU is a part of the GSM access network
• Handling FR/HR/EFR/AMR-NB to PCM conversion
• Most of its new markets in developing countries (plus capacity updates in developed countries)
© 2006 NOKIA 6 mikko.o.makinen@nokia.com 1.12.2006
Role of TRAU and MGW (2/3)
• MGW is a part of the 3G core network (Release4)
• MGW handles only user plane traffic
• Placed behind TRAU if co-operated with the GSM/EDGE access network
• Handling data type conversion (IP/ATM/PCM) in addition to the media format conversion
• Under active product development (new features + capacity updates)
RAN – Radio Access Network
GERAN – GSM/EDGE RAN
UTRAN – UMTS Terrestrial RAN
CS – Circuit Switched
PS – Packet Switched
RNC – Radio Network Controller
SGSN – Serving GPRS Support Node
GGSN – Gateway GPRS Support Node
MGW – Media Gateway
© 2006 NOKIA 7 mikko.o.makinen@nokia.com 1.12.2006
Role of TRAU and MGW (3/3)• Problem: Duplicate transcoders in 3G core/ GSM access network
situation• Expensive for the operator and multiple lossy transcodings decrease
the speech quality
• Solution 1: Avoid tandem transcoding with end-to-end codec negotiation
• Tandem Free Operation (TFO) – pack encoded bits inside 64kbit/s PCM stream, no bandwidth savings
• Transcoder Free Operation (TrFO) – send encoded bits directly over an IP/ATM network, saves also bandwidth compared to 64kbit/s PCM
• Does not solve the problem of duplicate hardware units
• Solution 2: Remove separate TRAU-unit, implement Ater-interface in MGW
• Cost efficient• Dynamic allocation of 2G/3G transcoding capabilities• Unfortunately Ater-interface is proprietary and thus this solution
works only in limited situations (access and core network from the same manufacturer)
© 2006 NOKIA 8 mikko.o.makinen@nokia.com 1.12.2006
DSP HW/SW (1/2)• “Why to use specialized DSP hardware with processor specific
Assembly code when commercial off-the shelf processors have higher clock rates, wider range of third party compilers/development tools/software/etc. and support for higher (more abstracted) programming languages (C/C++/Java..) that are easily ported for new hardware environments?”
• DSP processors are superior in certain application fields (price competitive and computationally demanding functions) due to their special characteristics
• Separate multiply-accumulate unit (e.g. for vector products)• Multiple memory fetches within single clock cycle• Fixed point arithmetic• Special instruction sets• Minimal and power consumption effective design
• Skilled Assembly programmer can beat modern C-compilers anytime in small, algorithm intensive tasks
• Tenfold margin is not extraordinary
© 2006 NOKIA 9 mikko.o.makinen@nokia.com 1.12.2006
DSP HW/SW (2/2)• However, modern transcoding units have new requirements for
DSP SW• Size of the software has explode• Dynamic functionality, lots of control oriented tasks• Shorter time-to-market cycles• Rapid hardware updates to increase capacity
► It is not possible to design each new hardware from scratch and reprogram the whole software for the new hardware
►Use of common and modular hardware units►Separation of the hardware dependent software from others►Separation of the control oriented and the algorithm intensive
pieces of software►Use of higher languages (mostly C) whenever its possible►Use of Assembly only when really needed!
© 2006 NOKIA 10 mikko.o.makinen@nokia.com 1.12.2006
TRAU and MGW software comparison• The development of these units have been relatively independent
due to their distinct functions and different historical background• However, today the functionality set of TRAU is almost an inclusive
subset of the corresponding MGW functionality set. Moreover, the MGW software offers several additional services such as the wideband AMR codec.
• The whole TRAU software was originally written in Assembly although in later releases some C-code was added -> simple and effective but nowadays unmanageable, error prone and stretched to its limits
• Not too optimized anymore, as the current version is only translated version of the previous release (optimized for a different processor)
• The MGW software has a more modern layered architecture (operating system, drivers, platform, application) making it flexible, modular and portable
• Even more detailed separation in application part, making it possible to for example outsource the development of standard speech codecs
© 2006 NOKIA 11 mikko.o.makinen@nokia.com 1.12.2006
Applying MGW software for TRAU environment (1/2)• Two similar products but both have distinct markets and
hardware environments, although both units use the same DSP currently (Texas Instruments’ TNETV3010)
• However, Nokia could enhance its software development and maintenance processes by reusing the more modern MGW software in TRAU unit. This is possible, as also the Assembly code is portable between units due to the same processors.
• Minimum target: same functionality and similar capacity
• Possible problems in external interfaces:• MGW SW has no support for direct serial port traffic that TRAU
uses for all user traffic• Operation & Maintenance (O&M) interface technically very
different• MGW’s dynamic resource control vs. TRAU’s static speech
coding channels
© 2006 NOKIA 12 mikko.o.makinen@nokia.com 1.12.2006
Applying MGW software for TRAU environment (2/2)
• Only few new modules
• However, lots of little changes and adjusting -> fiddly and time consuming project
• Only basic call through functionality, O&M interface ignored at this stage
• Simplified picture of the new Software
© 2006 NOKIA 13 mikko.o.makinen@nokia.com 1.12.2006
Performance of the new Software
• Clear performance advantage compared to the old TRAU SW
• Greatest difference in actual speech codecs (translated versus native code)
• Possibility to even double the capacity!
Average MIPS consumption of an EFR speech coding channel
0
10
20
30
40
50
60
70
Platform Serial PortForwarder
Others Speech codec Total
Module
MIP
S
First channel (withfixed structures)Additional channel
Old TRAU SW
© 2006 NOKIA 14 mikko.o.makinen@nokia.com 1.12.2006
Conclusions• Separate GSM transcoder unit have markets for years, although
larger investments should be reconsidered thoroughly
• The MGW software has clear performance advantage -> more handled channels per unit or less needed DSP hardware capacity
• Only minor changes needed for the new software -> possible to develop in parallel with the main MGW software -> only one software to maintain
• More flexible software for new features or other updates. AMR-WB is a possible newcomer for GSM networks in the future.
• Final product decisions not made yet, but used approach seems to be very promising
• Further study:• Implementation of the O&M interface if green light shown• Future of the AMR-WB codec (in GSM networks)
© 2006 NOKIA 15 mikko.o.makinen@nokia.com 1.12.2006
• Thank You!
• Questions/Comments?